does any know who or where i can my 14b turbine housing's inlet and outlet ported. And i am asking because i want it done some what "profesionally". ( i use that term loosely, i just what someone to do it who has done it before)

street and strip does good porting from what i've seen. or i could do it if ya throw a couple bucks my way, have air fittings and a dremel in the garage right now. its not pro, but i've had experience with porting out my ex mani and my old turbo.

edit- beer works too

i THINK loki might do it... or i'm sure he knows someone who would..

yeah, i'd talk to loki or possibly vince, i know vince does it for sure.

whose vince?

i don't remember his name on here; but he has a (9:1?) 2g spyder with a 14b...

buy an electric die grinder from HF and some grinding bits and go at it

it's not hard. i port-matched my old H22 intake manifold to a 68mm throttle body with a crappy dremel, not perfect but it turned out quite good.

i dont think an electric one would be powerful enough for the kind of metal on the turbo housings or the exh manifolds. especially, a dremel. that stuff's made of cast iron, it takes a while even for an air powered grinder with a iron bit to chew through all that rather than your aluminum (i'm assuming) intake. i think i put in about 2.5-3hrs on just porting out my exh mani, and that was not even including the polishing i did with the dremel.